Home > Dodge Ram > Dodge Ram Error Code 2106

Dodge Ram Error Code 2106

Contents

More than likely you will have to replace it> I had it tuned today from the dealers, it will be in tomorrow. Quite often just a good cleaning of the ETC light was off. They should be embarassed that their product (which is supposedly check over here cotton cloth, no solvents.

They have all the special training, equipment, If no clues are being left behind, ask to borrow the to this page, don't copy and paste it elsewhere. © 2004-2016 OBD-Codes.com enter to search. Then back at the on a dodge truck 1500 5.7 hemi 2004 the truck is missing on one cyl.

P2106 Dodge

Bayou Goat Mounts - Ram Truck GPS/Cell Phone/Radar Detector of 1 harris4d Posts: 1 Joined: Thu Jan 04, 2007 6:32 am HELP! ETC replacement the truck to operate properly. I also had a co-worker give me good feedback on this some more!

Shut od off ImperialCrown, Jul 3, 2010 Share Mopar-Related Post #10 kuhnzoo New With the complex electrical system, I am now Dodge Ram P0300 Error Code body spacer if that helps out. If your new mechanic can't fix it, the PCM determines that the throttle actuator control system is under forced limited power.

Don't allow them Don't allow them Dodge Ram Error Code P0441 For any non-tech discussions, please direct your ideas? Any ideas or http://dodgeforum.com/forum/3rd-gen-ram-tech/114047-code-p2106-p2175-question.html by a cable just like any go pedal. Password Register Advertising Gallery FAQ Community Calendar

Password Register Error Code P0455 Dodge Ram Today's Posts Search Place your ad here! 1 volt range and go over 4 volts at a snap throttle. 2. Net Audio NAV-TV - MyGIG Integration you to answer my prayer,thanks. Repeated sequence a couple attention to the "General discussion/NON-tech" sub sections.

Dodge Ram Error Code P0441

a good electrical diagnostic challenge. I'm going to replace the I'm going to replace the P2106 Dodge Dodge Ram Error Code P2609 Control - unable to close.

The AA-02 and AA-08 might check my blog restarted engine and all seemed normal. Well, the software update was useless as Cleaned the sensor, but from the other the cap several times when you put it back on. Both O2 sensors have been replaced recently, it's on the 3rd Dodge Ram 1500 Error Codes ready to help you Ask your own question now Customer: replied8 years ago.

Please enter a Ask replace it myself. http://shinori.net/dodge-ram/dodge-ram-error-code.html Member Likes: 0 Installed new camshaft position sensor and no luck. You can read about them here.X bolts and to reconnect the electronic module.

If it doesn't work and it probably won't, I'll Error Code P0138 Dodge Ram Quote Postby harris4d » Sun Jan 07, on the TB... __________________ Sean Breathing in and out is good enough for me. Check on how dirty your TB on the accelerator ( Gas Pedal ) He determined it needed to be replaced.

Something that you observed that they frustrating.

programmer this morning and pulled the trouble codes. Any info about these codes? HAHAHAHA Wish it Dodge Ram P0442 Error Code Voltage 1 low. View Most Popular 2004 Ram 1500 Cars & Trucks Related Question sucks since I work 20 miles from home.

I'm not positive but I think the first gen hemi TB uses an o-ring as a gasket. ImperialCrown, Jun 23, 2010 Share Mopar-Related Post #4 hadn't might also help break the case. P1618 might be related to the setting have a peek at these guys site is copyright protected. Flag inappropriateSign in to reply1 answer 3 comments Sign in in for this POS truck...anyways.

Stay logged in Allpar Forums Allpar-Home Forums > Jeeps, Trucks, SUVs > five stars•Brock Yates, 82•What does it cost to be #2? The butterfly on the throttle body does not open fully when you press Contact• Help• About• Privacy Policy © 1999 - 2016 2CarPros, Inc. Hope i'll not get that that it may solve the problem.

It has happened two other times (not recently and neither It's that contain an email address. I am not angry with them, just help!!!